Group: DynoMotion	Message: 5514	From: daveymahomh600e	Date: 8/4/2012
Subject: Maho MH600E Conversion

Hi Everyone,
I am going to convert my Maho MH600E from the original control to run under Mach3. My plan is to keep the Indramat 3TRM2 drive and the analog servos, so I am just checking to make sure that the Kanalog and Kflop will provide the necessary interface between Mach and the Indramat system. I understand the required signals are +/- 10V.
Thanks,
David.

Group: DynoMotion	Message: 5515	From: Tom Kerekes	Date: 8/5/2012
Subject: Re: Maho MH600E Conversion

Hi David,

I'm not familiar with that drive and you didn't include any links, but KFLOP+Kanalog will interface to most +/-10V Analog drives.

Regards